Nevion Flashlink Frame - DA-3GHD-2x4
This exported connector shows data from an DA-3GHD-2x4 module in a Nevion Flashlink frame.
About
This is an SNMP connector that is automatically generated by the parent connector Nevion Flashlink Frame.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Basic range | No | Yes |
| 2.0.0.x | Tree controls added to monitor parameters | No | Yes |
| 2.0.1.x | Audio Block status fix (ONLY for firmware 2.0.4) | No | Yes |
| 2.0.2.x | Changed naming structure | No | Yes |
| 2.0.3.x | Add 'card location' and 'label' to description column (for all tables) | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 2.0.1.x | 5.0.4 |
| 2.0.2.x | 5.0.4 |
| 2.0.3.x | 5.0.4 |
Installation and configuration
Creation
This connector is used by DVE child elements that are automatically created by the parent connector Nevion Flashlink Frame.
Usage
General Page
This page contains general information about an DA-3GHD-2x4 module, including:
- Type
- Card Status
- Chassis Number
- Slot Number
- Label
- Alarm Status
- Alarm Trap
- Alarm Count
- Main Element Name
GPIO Page
This page displays the General Purpose Input Output Table, which contains information about GPIO parameters.
It is possible to configure the Mode, Status, Descripion and Alarms.
Reclocker Page
This page displays the Reclocker Table, which contains information about reclocker parameters.
It is possible to see the Reclocker Num, Status, Bit Rate and to configure Config, ASI, Bandwidth and Alarms.
Voltage Page
This page displays the Voltage Table, which contains information about voltage measurements.
It is possible to configure the Upper and Lower Limit and Alarms. It's also possible to view the Nominal and Value in Volts and Watts.
Signal Input Page
This page displays the EQ Table, which contains information about EQ parameters.
It is possible to see the Num, Status and to configure Config and Alarms.