Nevion Flashlink Frame - FRS-HD-CHO-ASI
This exported connector shows data from an FRS-HD-CHO-ASI module in a Nevion Flashlink frame.
About
This is an SNMP connector that is automatically generated by the parent connector Nevion Flashlink Frame.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 2.0.3.x | Basic range. | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 2.0.3.x | 5.0.4 |
Installation and configuration
Creation
This connector is used by DVE child elements that are automatically created by the parent connector Nevion Flashlink Frame.
Usage
General Page
This page contains general information about an FRS-HD-CHO-ASI module, including:
- Type
- Card Status
- Chassis Number
- Slot Number
- Label
- Alarm Status
- Alarm Trap
- Alarm Count
- Main Element Name
- Active Alarms in System
Audio Generator Page
This page displays the Audio Generator Table, which contains information about all audio generators.
You can also configure the Audio Level and view the Audio Generators.
Audio Matrix - SDI Outputs Page
This page displays the Audio Matrix Table and SDI Outputs Table. In both tables, you can configure the Input.
Audio Processing - Embedder Page
This page displays the Audio Proc Table, which contains information about the audio processing capabilities of each card. You can configure the Mode and view the Audio Proc, Inputs and Outputs.
This page also displays the Embedder Table, which lists all embedders for those modules that have them. You can configure the Status, Word Length, and Alarms, as well as enable or disable the Embedder.
Changeover Page
This page displays the Changeover Table, which contains information about cho1BlockTable parameters.
It also allows you to configure the Mode, Current Input, Main, Backups, Rule, Latch, Hold and Lock Time, and Alarms.
Delay Page
This page displays the Delay Table, which contains information about delay parameters.
You can also configure the Status, Lines, Samples and Nanosecs delays.
GPIO Page
This page displays the General Purpose Input Output Table, which contains information regarding I/O blocks.
You can also configure the Mode, Status, Description and Alarms.
Reclocker Page
This page displays the Reclocker Table, which contains information about reclocker parameters.
You can also view the Reclocker Num, Status and Bit Rate, as well as configure Config, ASI, Bandwidth and Alarms.
Signal Input Page
This page displays the EQ Table, which contains information about EQ parameters.
It also allows you to view the Num and Status, as well as to configure Config and Alarms.
Signal Integrity Page
This page displays the Monitor Table, which contains information about monitor parameters.
It also allows you to configure Monitor Alarm, Error Count, Error Delta and Error Free Alarm, FF-CRC, AP-CRC, LOCK, ANCS, etc.
Sync Source Page
This page displays the Sync Source Table, which contains information about all sync source inputs.
You can also view the Sync Src, Type, Lines, Frame Rate and Structure, Sample Rate and Word Length, as well as configure Alarms.
Video Generator Page
This page displays the Video Generator Table, which contains information about all video generators.
It also allows you to configure the Pattern, Y, Cb and Cr.