Nevion Flashlink Frame - HD-OE
This exported connector shows data from an HD-OE module in a Nevion Flashlink frame.
About
This is an SNMP connector that is automatically generated by the parent connector Nevion Flashlink Frame.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Basic range | No | Yes |
| 2.0.0.x | Tree controls added to monitor parameters | No | Yes |
| 2.0.1.x | Audio Block status fix (ONLY for firmware 2.0.4) | No | Yes |
| 2.0.2.x | Changed naming structure | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 2.0.1.x | 5.0.4 |
| 2.0.2.x | 5.0.4 |
Installation and configuration
Creation
This connector is used by DVE child elements that are automatically created by the parent connector Nevion Flashlink Frame.
Usage
General Page
This page contains general information about an HD-OE module, including:
- Type
- Card Status
- Chassis Number
- Slot Number
- Label
- Alarm Status
- Alarm Trap
- Alarm Count
- Main Element Name
- Active Alarms in System
Voltage
This page displays the Voltage Table, which contains information about voltage measurements.
It also allows you to configure the Upper and Lower Limit and Alarms, as well as to view the Nominal effect and the Value in Volts and Watts.
Temperature
This page displays the Temperature Table, which contains information about temperature measurements.
It also allows you to configure the Nominal value, Upper and Lower Limit and Alarms, as well as to view the actual temperature Value.
Signal Input Page
This page displays the EQ Table, which contains information about EQ parameters.
It also allows you to view the Num and Status, as well as to configure Config and Alarms.
Optical Input Page
This page displays the Optical Input table, which contains information about optical input parameters.
It also allows you to view the Opt Input, Input Status and Signal Strength, as well as to configure the Opt Input Alarms.
Laser Page
This page displays the Laser Table, which contains information about laser parameters.
It also allows you to view the Laser Num, Wavelength, Power and Type, as well as to configure the Config, Status and Alarms.
Reclocker Page
This page displays the Reclocker Table, which contains information about reclocker parameters.
It also allows you to view the Reclocker Num, Status and Bit Rate, as well as to configure Config, ASI, Bandwidth and Alarms.
Cable Driver Page
This page displays the Cable Driver Table, which contains information about cable driver parameters.
It also allows you to configure the Config and Slew Rate.
Monitor Page
This page displays the Monitor Table, which contains information about monitor parameters.
Delay Page
This page displays the Delay Table, which contains information about delay parameters.
It also allows you to configure the Status, Lines, Samples and Nanosecs delays.
Audio Page
This page displays the Audio Block Table, which contains information about all audio I/O blocks.
It also allows you to configure certain parameters, such as Incoming and Outcoming Format, SRC, Peak and Max Level, Alarms, etc.
GPIO Page
This page displays the General Purpose Input Output Table, which contains information regarding I/O blocks.
It also allows you to configure the Mode, Status, Description and Alarms.
Video Page
This page displays the Video Table, which contains information about video parameters.