Nevion Flashlink QUAD-CHO-2X1-PB
The Nevion Flashlink QUAD-CHO-2X1-PB is a quad 2x1 3G/HD/SD-SDI changeover device with passive input bypass well-suited for quad-stream UHD/4K applications.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial range. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 0.9.3.1 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Connections
SNMP connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device
SNMP Settings:
- Port number: The port of the connected device (default value: 161).
- Get community string: The community string used when reading values from the device (default value: public).
- Set community string: The community string used when setting values on the device (default value: private).
Usage
This is an SNMP connector for the Nevion Flashlink QUAD-CHO-2X1-PB device. The element created with this connector consists of the following data pages:
- General: Contains general information on the module.
- Alarms: Displays a table listing all alarms associated with the card.
- Cable Driver: Displays a table with information about cable parameters. Also allows you to configure the Config and Slew Rate.
- GPIO: Displays a table with information regarding I/O blocks. Also allows you to configure the Mode, Status, Description and Alarms.
- Reclocker: Displays a table with information about reclocker parameters. Also allows you to configure Config, ASI, Bandwidth and Alarms.
- Temperature: Displays a table with information about temperature measurements. Also allows you to configure the Nominal value, Upper and Lower Limit and Alarms.
- Voltage: Displays a table with information about voltage measurements, including the nominal and measured voltage and current. Also allows you to configure the Upper and Lower Limit and Alarms..