Newtec 2280
The Newtec 2280 connector uses a serial connection to monitor and configure the corresponding device. Alarm monitoring and trending can be configured for most parameters.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version | - | - |
| 1.0.3.x | Software version 3 | 1.0.0.x | - |
| 2.0.0.x | Software version 2, software ID 6241 | 1.0.0.x | - |
| 2.2.4.x | Software version 2.4, software ID 6241 | 2.0.0.x | - |
| 2.2.42.x | Software version 2.42, software ID 6241 | 2.2.4.x | - |
| 2.6.1.x [SLC Main] | Software version 6.2, software ID 6279 | 2.2.42.x | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | N/A |
| 1.0.3.x | v3 |
| 2.0.0.x | 2.0 |
| 2.2.4.x | 2.4 |
| 2.2.42.x | t2.42_RC1 |
| 2.6.1.x | 6.2 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 2.6.1.x | No | Yes | - | - |
Configuration
Connections
Virtual connection
This connector uses a virtual connection and does not require any input during element creation.
Serial original Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (fixed value: 5933).
- Bus address: The bus address of the device (default: 100).
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The element created with this connector has the following data pages:
- General: Contains general parameters, as well as page buttons to the following subpages: Device Info, Display, Power Supply, Security, Ethernet, Serial, Outdoor, Internal, External, Config and Test.
- Modulator: Displays information about the modulator, such as frequency, bit rates and output level. Also contains page buttons to the following subpages: NCR, BBFraming, PHLA, Additional, BER, BISS, Rate Adapter, Frames and Packets.
- Alarms: Displays the status of more than 30 alarms that can occur on the device. Many of the parameters on this page can be configured for alarm monitoring in an alarm template in DataMiner Cube.