Norkring Modulation Robot
This connector is used to monitor a modulation robot and to set some configuration parameters.
About
The connector communicates with the device through SNMP in order to retrieve sources and status information and to configure sources and authorizations.
Installation and configuration
Creation
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
- Device address: Not required.
SNMP Settings:
- Port number: The port of the connected device, e.g., 161.
- Get community string: The community string used when reading values from the device, e.g., public.
- Set community string: The community string used when setting values on the device, e.g., private.
Usage
General
On this page, you can choose a monitoring source (Kies Monitoring Bron), allow the selection of a remote emergency source (Remote Noodbron Selectie), and monitor and configure transmitters (Zender) through an SNMP table, with parameters such as the source selection [Kies Bron], source status [Status Bron 1/2], automaton status [Status Automaat] and automaton actions [Actie Automaat].