Novel Supertv MIS
With the Novel Supertv MIS (Media Information System) connector, it is possible to monitor and manage Novel SuperTV's Media Information System software.
About
The connector retrieves information via SNMP and displays it in the element on two pages:
- The General page contains CPU, memory and disk usage information, as well as information concerning the operating system, the application and the database.
- The Alarms page contains information about alarms that occurred on the server.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | No | No |
| 1.1.0.x | Updated parameters based on the new MIBs because of new device firmware. | No | No |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Unknown |
| 1.1.0.x | Unknown |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device, e.g., 10.11.12.13.
- Device address: Not used.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string in order to read from the device. The default value is supertv.
- Set community string: The community string in order to set to the device. The default value is supertv.
Usage
General
This page contains information about CPU usage and memory usage, as well as information about the operating system, the application used and the hardware.
Two extra pages are available:
- Alarm Management: On this page, you can change the alarm settings of the CPU usage, the memory usage and/or the disk usage. You can also configure warning alarms for when a value is received that is high, but not high enough to take action (Pre Alarms). In other words, here you can change when the device generates an alarm entry.
- Configuration: On this page, you can see which modules are or are not configured.
Alarms
On this page, an overview is displayed of the alarms that have occurred.
This page contains a subpage:
- SNMP Traps: On this page, you can configure the necessary settings to receive SNMP Traps.