ONATi Bandwidth Aggregator
The ONATi Bandwidth Aggregator connector was developed with the goal of identifying the total received (RX) and transmitted (TX) bitrates of a certain path. For this purpose, it allows you to select which interfaces should be considered for that path. To facilitate the configuration, a filtered list of interfaces is displayed after you select a DataMiner element from the list of supported connectors.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | N/A |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Virtual connection
This connector uses a virtual connection and does not require any input during element creation.
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
How to use
The element has the following data pages:
- General: Displays the aggregated received (RX) and transmitted (TX) bandwidth, as well as the last time data was fetched from the included interfaces.
- Configuration
- Add Interface: Allows you to add a new interface to the monitored list. To do so, you can select an element and interface from a pre-filtered and ordered list. When the element has been selected, information such as the DMS element ID, protocol version and element state are displayed.
Notes
Supported connectors and parameters:
- CISCO ASR Manager - Rx/Tx sources: Bitrate column from Detailed Interface Info Rx/Tx tables
- RAD Data Communications ETX-203AX - In Bit Rate and Out Bit Rate columns from Interfaces table
- CISCO Manager - Rx/Tx sources: Bitrate column from Detailed Interface Info Rx/Tx tables