Ovarro Kingfisher Sensor
This connector provides a more detailed way of representing cards of the Ovarro Kingfisher device. Elements using this connector are created via the Ovarro Kingfisher parent connector.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
At present, this connector does not depend on a specific device firmware version.
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - |
Configuration
This connector is used by DVEs that are created by the parent element using the Ovarro Kingfisher parent connector.
How to use
Depending on the selected type of sensor during the creation of the sensor element, a different page is shown.
Digital Input / Digital Output
On the Digital Input/Output page, all 16 bit values of the card are shown.
The subpage with settings allows the configuration of these values. You can:
- Change the string representation that corresponds with the 0 or 1 value of each bit.
- Change the name of the parameter itself to better represent the meaning of each bit.
Analog Input
On the Analog Input page, all 8 sensor values are shown.
The subpage with settings allows the configuration of these values. You can:
- Change the name of the parameter itself to better represent the meaning of each bit.
- Change the units that go with the sensor value, depending on what is being measured. Currently supported units are "deg C" (degrees Celsius) and "V" (volt).
- Change the range of the sensor by setting the minimum and maximum value.