Ovzon OBP Spectrum

This is a smart-serial connector that communicates and retrieves spectrum data from the Ovzon Control Terminal. It uses the Spectrum Analyzer feature to display the trace.

Configuration

Connections

IP Connection - Primary

This connection defines the connection to the Ovzon Control device, where commands requesting spectrum data are sent. The following input is required during element creation:

SERIAL CONNECTION:

• Interface connection:

  • IP address/host: The polling IP or URL of the destination.
  • IP port: The IP port of the destination (default: 21963).
  • Bus address: The bus address of the device (fixed value: ByPassProxy).

IP Connection - Notifications

This connection defines where the trace data response should be sent for DataMiner to process it. It should point to the DataMiner Agent this element is created on. The following input is required during element creation:

SERIAL CONNECTION:

• Interface connection:

  • IP address/host: The polling IP or URL of the destination.
  • IP port: The IP port of the destination (default: 22000).
  • Bus address: The bus address of the device (fixed value: ByPassProxy).

How to use

The connector functions by sending individual commands to the device requesting spectrum data.

You can adjust the frequency range using the Spectrum Analyzer features.

Device-specific parameters like ports or the message source and destination can be configured on the General page.