Table of Contents

PDU eXperts ATS-16A-10N1

The PDU eXperts ATS-16A-10N1 connector monitors and controls the Power Switch unit of the same name through SNMP.

About

The connector polls relevant information from the device every 10 seconds or every hour.

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the device.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string used when reading values from the device. The default value is public.
  • Set community string: The community string used when setting values on the device. The default value is private.

Usage

This connector has several data display pages:

General Page

This page displays general information about the system:

  • Device ID and Firmware Version
  • System Up Time and Services
  • System Contact, Name and Location
  • Temperature and Humidity of the device and their respective Thresholds

Status Page

This page displays the Model Name, Model Number, Input A and B Status and Name and ATS Primary Input, as well as the Voltage, Total Current with Overload and Warning Thresholds, Electricity Carbon Emission Rate, Active Power, Power Factor, Apparent Power, Main Energy and Accumulated Energy.

There is one button on the page, Reset Accu Energy, which clears the value from the Accumulated Energy parameter.

Improve this page