PEAK System PCAN-Ethernet Gateway DR

The PCAN-Ethernet Gateway DR allows the connection of different CAN buses over IP networks. CAN frames are wrapped in TCP or UDP message packets and then forwarded via the IP network from one device to another. The PCAN-Ethernet Gateway DR features one LAN connection, two high-speed CAN interfaces, DIN rail casing, and support for an extended temperature range.

About

Version Info

Range	Key Features	Based on	System Impact
1.0.0.x [SLC Main]	Initial version.	-	-

Product Info

Range	Supported Firmware
1.0.0.x	2.9.0

System Info

Range	DCF Integration	Cassandra Compliant	Linked Components	Exported Components
1.0.0.x	No	Yes	-	-

Configuration

Connections

HTTP Main Connection

This connector uses an HTTP connection and requires the following input during element creation:

HTTP CONNECTION:

• IP address/host: The polling IP or URL of the destination.
• IP port: The IP port of the destination.

Initialization

No extra configuration is needed.

Redundancy

There is no redundancy defined.

Web Interface

The web interface is only accessible when the client machine has network access to the product.

How to use

The element created with this connector consists of the following data pages:

• General: Contains general parameters such as the Product Name, Serial Number, Name and Description. Also contains Interface Count information, and displays the available Hardware, Software, Website and JSON Interface Versions.

• Status: This page the contains the CAN and LAN Interfaces Tables and also the Defined Routes Table.

• The CAN Interfaces Table contains status information such as State, Bit Rate, Bit Rate Pre Scaler, Phase Segment, Sample Point and RX/TX Errors for each available CAN interface.

  • The LAN Interfaces Table contains information such as DHCP, IPv4 related and MAC for each available LAN interface.
  • The Defined Routes Table contains information such as the IP Address, Port, Packets, Errors and TCP Delay for each defined route.