Table of Contents

Palo Alto Networks PA-5050

The Palo Alto Networks PA-5050 is a firewall platform.

About

With the Palo Alto Networks PA-5050 connector, you can monitor and control the device with SNMP.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the device, e.g. 10.11.12.13.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string in order to read from the device. The default value is public.
  • Set community string: The community string in order to set to the device. The default value is private.

Usage

General page

This page displays general information about the device, together with the System Resources.

Interfaces

This page displays an overview of all the interfaces.

Physical Sensors

This page displays the Physical Sensor table, which contains a list of all the sensors with their measured values.

System, Chassis and Session

This page displays additional information about the device.

Improve this page