Papouch T2HE
Depending on the sensor connected to it, T2HE is able to measure temperature and humidity, and calculate the dew point. The Papouch T2HE connector is an HTTP connector that is used to monitor this device.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 6.7/17 (created 26.02.2019) |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
HTTP Main Connection
This connector uses an HTTP connection and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (default: 80).
- Bus address: If the proxy server has to be bypassed, specify bypassproxy.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The element has the following data pages:
- General: Contains the measured values of temperature, humidity and dew point.
- Extreme Values: Displays the lowest and highest values that have been measured since the last reset or since the element was created. The information is displayed in a table with the values and the times those values were detected. The maximum and minimum limits defined by the user are also displayed.