Table of Contents

Paradise RCP2-1100/1200

The Paradise RCP2-1100/1200 connector is used to display and configure information of the Paradise RCP2-1100 device.

About

This protocol can be used to monitor and control the Paradise RCP2-1100/1200 device. The connector supports one serial connection to communicate with the device.

Alarming and trending are enabled for parameters in the protocol.

Installation and configuration

Creation

SERIAL Connection:

  • IP address/host: The polling IP or URL of the destination, e.g., 10.245.83.193.
  • IP port: The port of the destination, e.g., 2104.
  • Bus address: The bus address of the device, e.g., 0. Valid values range from 0 to 255.

Usage

General Page

This page displays general information regarding the device, such as:

  • System Status
  • PSU Status
  • Control Mode
  • Etc.

There are also two page buttons:

  • Communications: Displays information regarding the communication settings.
  • PSU: Displays the PSU1 and PSU2 voltage.

Fault Status Page

This page displays the main status of the device. The page is divided in three major groups:

  • System Status
  • LNA Status
  • SSPA Status

In addition, with the Fault Setup page button, you can configure alarms raised by the device.

System Setup Page

On this page, you can configure the device.

SSPA Page

This page displays information regarding the SSPA.

Web Interface

This page displays the web interface of the device.

Improve this page