Plisch SCU Dual Drive DVB
Plisch SCU Dual Drive DVB is a transmitter that can broadcast live 4K (Ultra HD). This connector allows you to monitor information related to different aspects of the device, and also to control the entire device.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
- Device address: The device address.
SNMP Settings:
- IP port: 161
- Get community string: public
- Set community string: private
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The element consists of the data pages detailed below. For each of the pages, you can enable or disable polling.
General
This page contains the main settings to control the device, including input pre-selection, pre-selection mode, switch over control, events enabling and events priority.
It also allows you to monitor the amplifier state, the active exciter, the operation mode and the control unit live status. You can also force a fault reset. If polling is enabled, the refresh button allows you to trigger a live refresh.
SCU General
This page contains general parameters such as the system description, OID and system up time. The system OR last change displays the uptime of the latest system change.
This page also allows you to monitor SCU general parameters such as reserve system type, general control mode, warning, alarms and operation states. In addition, you can perform a system reset and switch over control.
DAB General
On this page, you can configure general parameters such as input pre-selection, pre-selection mode, events enabling and events priority.
You can also monitor the amplifier state, the active exciter, the operation mode and the control unit live status. You can also force a fault reset. If polling is enabled, the refresh button allows you to trigger a live refresh.
Dual Drive
This page contains the main monitoring parameters regarding change over, switch over, power, alarms and amplifiers. It also allows system and program configuration and control.
Tx Notify
This page allows you to monitor parameters related to transmitter notification, including exciter states, amplifiers, inputs and power.
Tx Output
This page allows you to monitor all parameters related to the transmitter output, and also to control the output setup.
Tx Amplifiers
This page contains two tables that allow you to monitor the amplifiers, Tx Amplifiers Config and Tx Amplifiers Statistics.
Tx System
This page contains Tx System Configuration and Tx System Statistics information, allowing quick live monitoring of the main transmitter system parameters.
Tx Operation
This page allows you to monitor and configure the main transmitter operation parameters.
Tx Channels
This page allows you to control all configurable parameters regarding channel regions.
Exciter
This page allows you to monitor both exciters (A and B). You can also control every parameter accessible via the events enabling and priority pages.
Exciter A/B Stats
These pages contain the statistical summary for exciter A and B, respectively.
DAB Exciter
This page allows you to monitor both DAB exciters (A and B). You can also control every parameter accessible via the events enabling and priority pages.
VTX
This page allows you to monitor the VTX parameters from exciters, transmitters, inputs, etc.