Prodys Prontonet
This is an SNMP protocol for the Prodys Prontonet device. ProntoNet is a multi-network audio codec, with a wide range of compression algorithms.
The protocol is designed to retrieve information and receive traps.
About
The connector needs an SNMP connection to retrieve information from the device.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
SNMP Main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: e.g., 10.253.116.62
- Device address: not required
SNMP settings:
- Port number: 161
- Get community string: public
- Set community string: private
Usage
Status
This page contains general parameters related to the device, such as Name, Serial Number, Backup Status, Net Type, Temperature, Fan Speed, Main and Backup Voltage, 5 V and 3.3 V Voltage and Vumeter.
There are two tables, one containing the Alarm History and the other showing the Line Status, Line Connection and Line Remote Number.
At the bottom of the page, a button provides access to the Streaming table, which displays information related to the Rx Buffer, Jitter, Lost Packets, Disordered Packets and Recovered Packets.
Encoder - Decoder
This page contains a table for the encoder and a table for the decoder, both showing the Algorithm, Mpeg Layer, Aac Mode, Frequency, Bitrate, Bits Per Sample, Law, Crc State, Aux Data State and Decoder Status.