Qbit Q552
The Q552 UECP processor addresses cable network providers who have to generate valid and complete RDS datasets for their local stations.
About
The connector uses SNMP to poll the Qbit Q552.
Installation and configuration
Creation
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
Channels
On this page, all monitored channels are displayed in a table.
Each channel can have 4 errors:
- Mec Rt
- Mec Pty
- Mec Pi
- Mec Ps
Traps
On this page, all trap destination entries are displayed.
For each entry, you can change the IP address, the UDP port and the Community settings. Each entry can also be enabled separately.
Web Interface
The web interface of the device.
The client machine has to be able to access the device. If not, it will not be possible to open the web interface.