RF Design FlexLink K3
The FlexLink K3 features a professional and flexible L-Band switch matrix system designed as a modular 6RU/19" master/slave chassis concept. The FlexLink K3 performs as an L-Band routing platform where any input can be routed to any or all outputs.
About
This connector is used to manage RF Design FlexLink K3 family switches.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | Yes | Yes | - | - |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
- Device address: The device address.
- Bus address: Not required.
SNMP Settings:
- IP port: The IP port of the device.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
General
This page displays information about the device hardware, the Unit Status, the PSU Status and the Input/Output configuration.
Input
This page contains the Inputs table, with the name of each input and related info, e.g., RF Power, Gain, Failure Alarms, Thresholds, etc.
Output
This page contains the Outputs table, with the Input Selected for each output as well as the Name of each output.
Matrix
This page displays a matrix with the size determined in the input/output configuration.
In this Matrix, you can select crosspoints to define which input is connected to which output. You can also change the name of inputs and outputs by renaming the labels of the matrix.
Web Interface
This page displays the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.