Riedel Communications ConnectDuo
This connector retrieves information from an ISDN & POTS Audio Codec via serial communication and makes it possible to configure certain settings.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version. | - | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: Baudrate specified in the manual of the device, e.g., 9600.
- Databits: Databits specified in the manual of the device, e.g., 7.
- Stopbits: Stopbits specified in the manual of the device, e.g., 1.
- Parity: Parity specified in the manual of the device, e.g., No.
- FlowControl: FlowControl specified in the manual of the device, e.g., No.
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
- Bus address: The bus address of the device.
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
How to use
The element created with this connector consists of the following data pages:
- General: Displays important information such as the Processor Load, Temperature, and Login Status of the device.
- Audio: Displays the Audio Mode, Requested Audio Mode, Audio Decoder Mode and Audio Encoder Mode for line 1 and line 2 of the device.
- Call Control: Displays the Connection State, Caller ID, and Last Caller ID of line 1 and line 2 of the device. You can also set Auto Answer to On or Off, disconnect the connection to line 1 or line 2, redial the last caller ID, and call a new configurable telephone number.
- Audio Settings: Allows you to configure the Audio Input Level (dBu), Audio Output Level (dBu) and Audio Mode for line 1 and line 2 of the device.
- Auto Answer Settings: Allows you to set Auto Answer to On or Off, and configure the Auto Answer Delay.
- ISDN Settings: Allows you to configure the ISDN Protocol, disable incoming calls and define Permanent ISDN Layer 2.