Rittal CMC III
The Rittal CMC III is a processing unit for a network with sensors/CAN bus. This connector will allow the user to view everything the Rittal CMC III monitors.
About
The connector gets the information from the Rittal CMC III through SNMP.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | No | Yes |
| 1.0.1.x [SLC Main] | Discreet value for Status changed from 45 to 4 for Off 60s | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | V5.13.00_8 |
| 1.0.1.x | V5.1300_8 |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- IP port: The IP port of the device: 151.
- Get community string: public
- Set community string: private
Usage
General
This page displays general parameters, such as URL, Firmware Version, Serial Number, etc.
Setup General
This page allows you to define the active communication and set the ports that should be used.
Setup NTP
On this page, you can set the NTP settings.
Device Info
This page displays more detailed general parameters, such as Number of Vars, Number of Messages, etc.
Message Info
This page displays several statistics related to messages, as well as the CMC III Message Table, which contains both information and configurable parameters.
Power Info
This page displays information such as the Unit Frequency, Unit Power Active, Unit Energy Active, Phase L1, as well as the status of each of the sockets.
Temperature Info
This page displays information about the temperature, such as the Temperature Value, Temperature Offset, and Temperature Status. It also contains a toggle button that allows you to enable or disable the polling of these parameters.
Humidity Info
This page displays information about the humidity, such as the Humidity Value, Humidity Offset, and Humidity Status. It also contains a toggle button that allows you to enable or disable the polling of these parameters.
Web Interface
This page displays the web interface of the device. However, note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.