Table of Contents

Rohde Schwarz DVB-T N+1 Nx8000

With this connector, you can gather and view information from the Rohde Schwarz DVB-T N+1 Nx8000 Switch Over unit, as well as configure the device.

About

This connector uses SNMP to monitor the Rohde Schwarz DVB-T N+1 Nx8000 device.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP Connection:

  • IP Address/host: The polling IP of the device, e.g., 10.64.7.62.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string in order to read from the device. The default value is public.
  • Set community string: The community string in order to set to the device. The default value is private.

Usage

General Page

This page displays general information about the device, such as the Serial Number, NTP Configuration and Software Version.

CCU Page

This page displays information about the switch over unit.

Improve this page