Rohde Schwarz NETCCU700
This connector is developed for devices such as the Rohde Schwarz NETCCU 700 Controller Console. The connector polls parameters from the device to enable monitoring of the transmitters.
About
With three timers, all parameters of the device are polled. The parameters are displayed on several different pages. Some parameters allow you to configure settings.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | Yes | No |
| 1.0.1.x | Added DVEs | Yes | No |
| 1.0.2.x | Added a new button "Switch Over with Reset" | Yes | No |
Exported connectors
| Exported Connector | Description |
|---|---|
| Rohde Schwarz NETCCU 700 Transmitter 1 | Transmitter 1 |
| Rohde Schwarz NETCCU 700 Transmitter 2 | Transmitter 2 |
| Rohde Schwarz NETCCU 700 Transmitter 3 | Transmitter 3 |
| Rohde Schwarz NETCCU 700 Transmitter N | Backup transmitter |
Installation and configuration
Creation
SNMP connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device, e.g., 10.17.3.3.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
Settings
On this page, settings can be done for transmitters and programs.
Status
This page displays general status information. You can also view status information for each transmitter via page buttons. The program status can be monitored in the same way.
Register
This page displays register parameters for each transmitter.
Trap Masks
On this page, every parameter can be enabled or disabled. The same configuration can be set for each transmitter.
Trap Events
This page displays all trap events, in a similar way as on the Trap Masks page.
Web Interface
This page provides access to the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.