Rohde & Schwarz NetCCU800

About

This is a DataMiner connector for the Rohde & Schwarz NetCCU800 control unit, which is commonly used for FM and TV transmitters.

Dual device type support: Switch between DVB and ISDBT device configurations for flexible deployment scenarios.
Comprehensive module monitoring: Monitor and control DVB receivers, transmitters, exciters (A & B), amplifiers, and pump units.
Event and alarm management: Real-time SNMP trap reception with configurable event masks, priority levels, and fault tracking across GPS, NSU, and pump unit events.
Transmitter control: Remote restart capabilities, fault reset functionality, and transmitter command execution.
SFN delay calculation: Automatic calculation of synchronous frequency network (SFN) delay parameters between exciters A and B.
Amplifier management: Status monitoring, alarm tracking, and rack-level information for system amplifiers including Sx801 models.
Network time synchronization: Built-in NTP server configuration for accurate time management.
RF probe monitoring: Track and configure RF probe parameters for signal quality assessment.
Software update management: Remote software update configuration and deployment capabilities.
Trap sink configuration: Customizable SNMP trap destination management for integration with monitoring systems.

The Get/Set community strings are required for reading and setting values onto the device.

For detailed technical information, refer to our technical documentation.