Rohde Schwarz THU9 - Transmitter

The Rohde Schwarz THU9 - Transmitter connector can be used to display and configure information of the related device.

About

An SNMP connection is used in order to successfully retrieve and configure the information from and on the device. There are also different possibilities for alarm monitoring and trending .

This connector is automatically generated by the connector Rohde Schwarz THU9.

The following pages are available in the connector:

• General: Contains general information about the most important parameters and different modes.

• Transmitter Information: Contains detailed information about the transmitter and the available exciters. When only one exciter is available, only the left exciter (ExA) will be filled in. When both exciters are available, both exciters will be filled in (ExA and ExB).

• Amplifiers: Subpage displaying the state of the amplifiers.

• Status: Displays the state of the available parameters. When only one exciter is available, some parameters (ExB parameters) will not be filled in.

Product Info

Connector Version	Device Firmware Version
1.0.0.1	tce900-103250

Installation and configuration

Creation

This connector is used by DVEs that are automatically created by the parent element. No user input is required.

Usage

General

This page contains general information about the transmitter.

Here you can set the Amplifier Mode and Operation Mode, and set the transmitter's Forward Power Threshold.

Transmitter Information

This page contains detailed information about the transmitter and the available exciters. When only one exciter is available, only the left Exciter (ExA) will be filled in. When both exciters are available, both exciters will be filled in (ExA and ExB).

On this page, the Transmitter Power, Active Input and Preferred Input can be set.

Status

This page displays the state of the available parameters. When only one exciter is available, some parameters (ExB parameters) will not be filled in.