Rohde Schwarz TMU9 FM Dual Drive IRT
The Rohde Schwarz TMU9 FM Dual Drive IRT is a redundant FM transmission system. This connector can be used to monitor and control this system. The connector has a page with general information and two pop-up pages for the configuration of traps. The connector uses SNMP to retrieve and configure data.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | N/A |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The General page displays the Transmitter status, Pr‚sence RF, Local Mode, Faute (Fault Status) and Warning status, etc. Use the Refresh Table button to trigger the immediate polling of these parameters. The information is bundled in the Table Service. You can also define a Description for the single table entry.
There is a page button that will display the Trap configuration for each of the previously mentioned parameters. As these parameters are not polled automatically, use the Refresh Traps button to update them.
A second page button displays the Trap Handler subpage, which allows you to enable or disable Trap Handling and to set the Trap Delta.
Note: A received trap will only trigger a parameter update if Trap Handling is enabled and the difference between the trap event counter and the previous trap event counter is more than the value of the Trap Delta parameter.