Rover Instruments MFE 802

The Rover Instruments MFE 802 is a digital multi-frontend DVB device, specifically developed for broadcasters, to give them flexible and multi-task functionality thanks to its modular and cutting-edge design.

About

The Rover Instruments MFE 802 connector provides a monitoring interface to get/set information from/to the device.

Further information is available here: http://www.roverinstruments.com/prodotti.php?idp=4&camblingua=2&changelan=yes&idprod=13

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

• IP address/host: The polling IP of the device, e.g., 10.11.12.13.
• Device address: Not used.

SNMP Settings:

• Port number: The port of the connected device, by default 161.
• Get community string: The community string in order to read from the device. The default value is public.
• Set community string: The community string in order to set to the device. The default value is private.

Usage

General

General information about the device can be checked and set on this page. Also here is present the current alarms present on the device.

SAT 8 PSK

Information related to the Satellite Status, Configuration and Information can be accessed here.

COFDM 2K/8K

On this page is present the OFDM Status, Configuration and Information.

Decoder

Decoder Information, Status, Configuration and Alarms and also Mask configuration is available on this page.

Commom Interface

All information related to the Commom Interface can be found here.

ASI Switch

All related ASI Switch Configuration is available under this page.

ASI Analyzer

All information related to the ASI Analyzer can be found here.

Advanced ASI Analyzer

All information related to the Advanced ASI Analyzer can be found here.

Terrestrial T2

All information related to the Terrestrial T2 can be found here.

Dual Commom Interface

All information related to the Dual Commom Interface can be found here.

Web Interface

The client machine has to be able to access the device. If not, it will not be possible to open the web interface.