SA ROSA EM - Vikinx
The Rosa EM - Vikinx connector will display information related to a Vikinx device connected to the ROSA EM device. The displayed information is organized according to the Rosa EM web application. In addition, this connector also provides the possibility to perform sets on Vikinx devices.
About
The ROSA EM - Vikinx connector is used to obtain information from Vikinx devices connected to the Rosa EM device. An SNMP connection is used in order to successfully retrieve and configure the device's information.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and Configuration
Creation
SNMP main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP Connection:
- IP Address: The polling IP of the Rosa device, e.g., 10.55.48.31.
- Device address: The device address can be found on the page Vikinx Devices of the connector Rosa EM.
SNMP Settings:
- Port number: The port connected to the device (by default 161).
- Get Community String: The community string needed to read from the device. The default value is public.
- Set Community String: The community string needed to set to the device. The default value is private.
Usage
Each element created for a Vikinx device connected to Rosa EM will contain the following pages:
- Input Output Settings: Matrix representation for input/output setting.
- Input Output Settings Table: Output values from matrix displayed as normal parameters.
- Vikinx - Alarms: Alarms for the Vikinx device.
- Vikinx - Properties: Properties for the Vikinx device.
- Vikinx - Status: Status parameters for the Vikinx device.