SED Decimator CarrierWatch
This connector is used to monitor carrier measurements performed by a SED Decimator device. This device is a spectrum analyzer that performs measurements on carriers and that can send SNMP traps when some conditions are met. The SED Decimator CarrierWatch connector collects those traps and displays them in a table. The connector also retrieves generic information about the device.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to Use
General
This page displays general information about the device: Device Status, Up Time, etc.
Measurements
This table displays the carrier measurements performed by the device. This table is filled in entirely based on traps.
SNMP Information
This page displays general information about the SNMP interface.
SNMP Statistics
This page displays statistics related to the SNMP interface.