SEE Telecom Acsys 2Rx Us
This protocol uses SNMP to monitor the SEE Telecom Acsys 2Rx Us receiver.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Development version. | - | - |
| 1.1.0.x [SLC Main] | Main version, with two timers: fast timer (every 30 s) for important parameters and slow timer (every hour) for other parameters. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | N/A |
| 1.1.0.x | N/A |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
| 1.1.0.x | No | Yes | - | - |
Configuration
Connections
Virtual connection
This connector uses a virtual connection and does not require any input during element creation.
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
How to use
The element created with this connector consists of the following data pages:
- General: Contains general information and allows you to switch the PS switch on and off.
- Optical: Contains the measurements for different optical power parameters. Also allows you to change parameters on the device. You can also normalize the optical parameters via two buttons.
- RF: Allows you to monitor and configure attenuation parameters.
- Switch: Allows you to change the switch options.