SEE Telecom eAcsys 2Rx Us
SEE Telecom eAcsys 2Rx Us is a key connector of the headend used as an HFC upstream receiver (the successor of Acsys). The integrated eAcsys platform is used for the segmentation of the CATV network.
About
Version Info
| Range | Features | Based on | System Impact |
|---|---|---|---|
| 1.1.0.x [SLC Main] | - Bus addresses adapted to allow addresses above 9. - Conversion of Optical Power modified. - Layout modified. - Normalization fixed. - Connector available on Repo Manager. - Unnecessary parameters removed and fast timer interval reduced. |
1.0.0.x | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.1.0.x | 1.1 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.1.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Connection - Main
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: 10.210.64.11
- IP port: 161
- Bus address: 12
SNMP Settings:
- Get community string: user
- Set community string: private
Initialization
No additional configuration of parameters is needed
Redundancy
There is no redundancy defined.
How to use
The General page contains basic information regarding the unit. This includes the following:
- Identification: Name, Type, Serial Number, Software, Hardware and BIOS Version, Rack and Slot Number
- Statistics: Uptime, Temperature.
The Optical page of this connector provides an overview of the Rx KPIs (both Rx A and Rx B), including the Status, Optical Input Power, and Wavelength. On the Normalize Rx A and Normalize Rx B subpages, you can normalize the Optical Input Power of Rx A and Rx B, respectively.
The RF page contains details regarding the radio frequency module for both Rx A and Rx B. You can view and modify the value for the attenuator for both Rx A and Rx B, and you can view information regarding the Automatic Level Control (ALC).
The Switch page displays the Unit Mode, which can be set to Redundant or Segmented. On this page, you can set the Receiver Control Switch (CTL) for both Rx A and Rx B to Open or Closed.
All of this data is retrieved using SNMPv1.