Table of Contents

SEE Telecom eAcsys NMS_X_eACSYS Dual RX US

The SEE Telecom eAcsys NMS_X_eACSYS Dual RX US connector is exported by the SEE Telecom eAcsys NMS connector. It displays information regarding a receiver module compatible with an SEE Telecom eAcsys system. The connector is used in order to monitor and control Optical/RF/Switch features*.*

About

With this connector, you can inspect general information about the module, monitor the optical communication of the connector, monitor and control any RF features from the receiver, and change any settings concerning the module's switch.

Product Info

Range Device Firmware Version
1.0.0.x Compatible with software version 1.1.
2.0.0.x Compatible with software version 1.1.

Installation and configuration

Creation

The connector is automatically generated by the SEE Telecom eAcsys NMS connector.

Usage

General

This page displays the following information on the left side:

  • Name
  • Type
  • Configuration
  • Serial Number
  • Software Version
  • Hardware Version
  • BIOS Version
  • Rack Number
  • Slot Number
  • Module Status

On the right-hand side of the page, the following parameters are displayed:

  • Uptime
  • Total Uptime
  • Number of restarts
  • Temperature
  • Fan

Optical

This page displays the optical measurements from the receiver module with the following parameters:

  • Rx 1&2 Status
  • Rx 1&2 Optical Input Power
  • Rx 1&2 Wavelength
  • Rx Combined Status

In addition, the Refresh button can be used to refresh the displayed information.

RF

This page displays the RF measurements from the receiver module with the following parameters:

  • Rx 1&2 Attenuator (also user controllable)
  • Rx 1&2 Attenuator Status
  • Rx 1&2 Attenuator Control Mode
  • Rx 1&2 ALC Position
  • Rx 1&2 OMI/Channel
  • Rx 1&2 Output Level Target

In addition, the Refresh button can be used to refresh the displayed information.

Switch

This page displays the following information:

  • Routing Mode (Rx 1 only)
  • Rx 1&2 Routing Status
  • Rx 1&2 Backup Status
  • Rx 1&2 Backup Return Mode
  • Rx 1&2 Power Save
  • Rx 1&2 CTL Switch

In addition, the Refresh button can be used to refresh the displayed information.

Improve this page