Table of Contents

SEE Telecom eAcsys Rx Ds

About

This connector makes it possible to monitor a SEE Telecom eAcsys Rx Ds Receiver with SNMP. The retrieved parameters are displayed on several pages, depending on the kind of parameter.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the device, e.g., 10.67.7.206
  • Device address: The bus address of the device, e.g., 4

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community The community string needed to read from the device. The default value is public.
  • Set community string: The community string needed to set to the device. The default value is private.

Usage

The following pages are displayed:

  • General
  • Optical
  • Main RF
  • Backup RF
  • RF Switch
Improve this page