SPX FLOW - Delair Etsiline CommPact
The Etsiline CommPact is an air dryer with compact dimensions. This connector can be used to monitor and configure operational settings of this device.
About
All parameters are retrieved via SNMP polling or via SNMP traps.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 1.03.01 |
Installation and configuration
Creation
SNMP Main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
General
This page contains relevant information about the operation of the device, such as Runtime, System Phase and Valve Y3 Duty Cycle.
It also includes Pressure, Humidity and Dewpoint sensor readings, which are updated every 10 minutes or whenever a corresponding SNMP trap is received.
Finally, it also contains information about the configuration of the Sensors, Alarms, Runtime and Network.
Configuration
This page allows you to configure several alarm settings (Pressure and Humidity thresholds and hysteresis, Compressor Runtime Alarm and Alarm Delay), as well as Date, Time and Network settings.
Test Status
This page displays the current status of device I/O components, including Valve and Relay positions and Analog Input Voltage.
Web Interface
This page connects to the web interface of the device. However, note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.