SatService ACU-ODM
The SatService ACU-ODM connector is used to monitor and configure the ACU-ODM Antenna Controller.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 2.2.081 2019-12-10 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
HTTP Main Connection
This connector uses an HTTP connection and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination, default value: 80.
- Bus address: If the proxy server has to be bypassed, specify bypassproxy.
Initialization
No additional configuration of parameters is necessary in a newly created element.
Redundancy
No redundancy is defined in the connector.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to Use
The connector will use HTTP GET calls to retrieve and set the parameters from the device.
The Targets table is polled incrementally, meaning that the target with ID 0 is polled first, up to 199. Should one of the calls fail (status code is not 200) during the polling, then the polling of the Targets table will fail.