Satec PM130 Plus
The PM130 PLUS is a compact, multi-function, three-phase AC power meter, designed to meet the requirements of users ranging from electrical panel builders to substation operators.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | General monitoring parameters. | - | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: Baudrate specified in the manual of the device, e.g., 9600.
- Databits: Databits specified in the manual of the device, e.g., 7.
- Stopbits: Stopbits specified in the manual of the device, e.g., 1.
- Parity: Parity specified in the manual of the device, e.g., No.
- FlowControl: FlowControl specified in the manual of the device, e.g., No.
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
- Bus address: The bus address of the device.
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
How to use
The element generated with this connector consists of the following data pages:
- General: Displays the majority of the power meter parameters, such as parameters related to tension, amperage, power, energy, etc.
- Device Info: Displays the COM1 and COM2 communication information, i.e., the Protocol, Interface, Address and Baud Rate. The MAC Address, IP Address and Default Gateway are also displayed on this page.
- Basic Reading: Displays the basic readings of the three-phase AC power meter: Neutral Tension, Power in Watts, Amperage and Power Factor for phases 1 to 3.
- Energy: Displays the current Active Tariff and the Energy values for all three tariffs, in kWh and in kVArh, as well as the Total Energy value in kWh, kVArh and in kVAh.
- Phasor: Displays the Neutral Tension and Amperage for phases 1 to 3, as well as the Tension 1 - 3 Phase and Amperage 1 - 3 Phase.
- Phase 1 - 3: These pages display the Phase 1 - 3 Tension, Neutral Tension, Amperage, Power in Watts, VA and VAr, Phase 1 - 3 THD and Current 1 - 3 THD.