Scopus Network Technologies IRD-2900
The IRD-2900 is a broadcast-quality decoder, decryptor and interface converter that provides MPEG-2 and AVC SD decoding, advanced transport stream processing, cutting-edge IP processing technologies and a variety of front ends, including DVB-S2, MPEG over IP and more.
About
The Scopus Network Technologies IRD-2900 connector is used to monitor and control the Scopus Network Technologies Integrated Receiver decoder 2900.
The data for monitoring and controlling the device can be found on different pages, each pertaining to a specific part of the device.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.1.2.1 | Review: Update from 'displaycolumn' to 'naming'. Changed Name/Description/Displaying values. | No | No |
| 1.1.2.2 | Sets Reviewed. Added SNMP type tags. | No | No |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.1.2.x | 4.6 |
Installation and configuration
Creation
SNMP main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device, e.g. 10.11.12.13.
- Device address: Not used.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string in order to read from the device. The default value is public.
- Set community string: The community string in order to set to the device. The default value is private.
Usage
General page
This page displays general information about the device.
There is a page button available, Set Date/Time, which opens a subpage where the date and time can be set.
Underneath that button, there is a Reset button, which can be used to reset the values.
Alarms page
This page displays two tables:
- Alarm Status Table: Displays different alarm descriptions and shows if they are in Alarm or Ok.
- Trap Destination Table: Displays the destination IP of the incoming traps.
Demodulator page
On this page, you can modify the settings for the receiver.
IP Front-End page
On this page, the network settings can be modified.
Service page
This page displays the different services.
There are three page buttons available that will each open a subpage where additional settings can be done.
Underneath these, there is a Load button, which can be used to load different services in the ServiceTable.
Video page
On this page, you can modify the settings for Video 1 and Video 2.
There are three page buttons available that will each open a subpage where additional settings are displayed.
Audio 1-2 & Audio 3-4 page
The Audio 1-2 and Audio 3-4 pages are similar, each showing information related to its specific audio channels.
On these pages, the settings for the audio channels can be modified.
There is one page button available, MPEG Info, which opens a subpage with additional information.
Stream page
This page displays information regarding the stream.
A number of sets can be performed on this page, and there are also ten page buttons available. Each of these page buttons will open a subpage with additional information regarding the subject described on the button.
Satellite Delivery System page
This page displays one table with information regarding the satellite delivery system.
Click the Load button at the top to have data displayed in the table.
Web Interface
This page displays the webpage of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.