SeaChange Stagis
This connector can be used for basic KPI monitoring for SeaChange Stagis devices: interfaces, storage, software and more generic info.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
How to use
This connector contains four main data pages to monitor Stagis devices:
General: Displays general information about the server and the system. Contains the following page buttons:
Network Services: Displays a table listing the service entries installed on the server.
- LAN Manager: Displays detailed information such as software versions, general counters of bytes sent/received, network I/O operations, etc.
- Device Info: Displays the Memory Size, the amount of physical read-write main memory and the Processor Table, which lists the processors contained by the host.
Interface: Contains the Interface table, displaying detailed information on each interface entry, such as MTU, I/O Bit Rates, Admin and Operational Status, etc.
Storage: Contains three tables with detailed data about Logical Storage, Disk Storage and the different Disks Partitions.
Software: Contains two detailed tables with the installed and running software of the system.