SeaLevel Systems SEAIO-410
This connector uses a serial connection to communicate with the SeaLevel device over TCP.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Bus address: The bus address of the device. This must match the MODBUS address of the device.
How to use
Isolated Inputs
This page contains the Isolated Inputs table.
Relay Outputs
This page contains the Relay Outputs table.
Polling Configuration
This page displays a polling configuration table where you can define the polling interval. The acceptable range is from 1 s up to 1000 s. Use the Reset Default button to assign the default frequency, and use the Disable button to assign an exception value (-1) to the group that disables polling.