Table of Contents

Siemens Sentron PAC3200

With this connector, it is possible to monitor a Siemens Sentron PAC3200 power meter device.

About

This connector uses serial communication to monitor a Siemens Sentron PAC3200 device. The protocol used for the serial communication is Modbus TCP. All commands and resonses are in the standard format of Modbus TCP.

Installation and configuration

Creation

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

  • IP address/host: The polling IP of the device, e.g. 192.168.236.79.
  • IP port: The port of the connected device. For Modbus this is often port 502.
  • Bus address: The bus address of the connected device, e.g. 4.

Usage

General Page

This page displays general information about the device:

  • Different Phase Voltages
  • Different Phase Currents
  • Different Phase Power Measurements

Phase 1 Page

This page displays power, voltage and measurements of phase 1.

Phase 2 Page

This page displays power, voltage and measurements of phase 2.

Phase 3 Page

This page displays power, voltage and measurements of phase 3.

Improve this page