Sky UK Commercial Minutes Workflow
This connector is used by enhanced services that contain elements of the protocol Sky UK Commercial Minutes. With this connector, all the alarms are gathered in a single table.
About
To use this connector, create a service that uses it as its service definition, add the necessary elements and select the parameters to add to the service. In this case, these are alarm parameters.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
This enhanced service needs to be configured with only the following properties:
Elements:
- Protocol: Sky UK Commercial Minutes
Parameters:
- Bus Address
- Channel Type
- Commercial Minutes (Current Hour)
- Commercial Minutes (Hour +1)
- Commercial Minutes (Hour +2)
- Commercial Minutes (Potential Breach)
- Commercial Minutes (Previous Hour)
Usage
Early Warning List
This page displays a table with the alarms from each element that was configured for the service. The table displays the Cause, Alarm State, Channel, Alarm Time and Target UI. Depending on the channel type (General, Entertainment and Sports) of the element, some alarms might not be displayed.
Device Data
This page contains information about the element Commercial Minutes associated with the service. It displays the state of the Minutage Breach Current Hour, Minute Breach In 2 Hours, Minute Breach Next Hour, Potential Minutage Breach and Channel Type.
It also shows the Service Status value. When this value is Off-Air, this workflow will not trigger any alarms. For other values (NA or On-Air), the workflow will run as expected.