Sky UK Master Follow Tags Workflow
This connector is used by enhanced services that contain elements of the protocol Sky UK VICC and Sky UK BSS. With this connector, alarms are generated according to predefined rules.
About
To use this connector, create a service that uses it as the service definition, add the necessary element and select the parameters mentioned below.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
service Main Connection
This connector uses a service connection and requires the following input during element creation:
SERVICE CONNECTION:
Elements/Parameters:
Sky UK VICC (Master element)
- Data Update Trigger
Sky UK VICC (Follow element)
- Data Update Trigger
- Channel From User
- Expected Follow Bus
-
- Data Update Trigger
From version 1.0.0.11 subscription parameters have changed
Future Events Table
Sky UK VICC (Follow element)
- Future Events Table
- Channel From User
- Expected Follow Bus
-
- BSS Table
Usage
Alarms
This page displays the Early Warning List Table with the alarms from each element that was configured for the service. The table displays the Cause, Alarm State, Channel, Alarm Time and Target UI.
Device Data
This page contains the state of the workflow decision nodes. It displays the Expected Follow Bus and detection of the Master and Follow element. It also shows the value of the Channel Bus and the Service Status: when this is Off-Air, this workflow won't trigger any alarms, for other values (NA or On-Air), the workflow will run as expected.
Subscriptions Active
Table with subscribed parameters of the service.