Sky UK Watershed Alarming Workflow
This connector is used by enhanced services that contain elements of the protocol Sky UK VICC. With this connector, alarms are generated according to predefined rules.
About
To use this connector, create a service that uses it as the service definition, add the necessary element and select the parameters mentioned below.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
service Main Connection
This connector uses a service connection and requires the following input during element creation:
SERVICE CONNECTION:
Elements:
- Protocol: Sky UK VICC
Parameters:
- Data Update Trigger
- Channel From User
Usage
Alarms
This page displays the Early Warning List Table with an entry for each current and future event. When the service has a +1 variant, it also displays the entries for that variant. The table displays the Cause, Alarm State, Channel, Alarm Time and Target UI.
Device Data
This page contains some internal parameters. First one should configure if this channel is a +1 variant using the toggle button. Second, the VICC Update parameter is the last update trigger received from the VICC and will also trigger internal processing. Third, the VICC DMA-Elem ID parameter is the reference to the VICC element configured in the service, it is used to find the correct element to request data from and is automatically filled in. Finally, it also shows the value of the Channel Bus and the Service Status: when this is Off-Air, this workflow won't trigger any alarms, for other values (NA or On-Air), the workflow will run as expected.
Subscriptions Active
Table with subscribed parameters of the service.