Snell Wilcox IQH3A RollCall
The Snell Wilcox IQH3A RollCall is a 3U rack unit accepting up to 16 modules.
About
This connector is an application-specific protocol for control and operation of units. The Snell Wilcox IQH3A RollCall connector uses a smart-serial connection.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 5.30.21 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
Serial main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device, e.g., 192.168.14.11.
- IP Port: The IP port of the device, e.g., 2050.
- Bus address: Used to fill in the unit address and the unit port, e.g., 20.00 for unit address 0x20 and unit port 0x00.
Usage
General Page
This page contains the Display parameter, as well as parameters of the output display.
Setup Page
This page contains information about the chassis, e.g., Product, Software Version, Build. Buttons allow you to restart the device (Restart), to Enable**/Disable** the module, or to save and clear memory.
Finally, you can also name the different inputs.
Ethernet Page
This page displays the Unit IP Address Settings and Unit State. It also allows you to set up Client IP Ranges.
RollCall IP Page
This page allows you to configure the RollCall IP.
Log Server Page
This page provides an overview of the Log Server information and allows you to enable/disable logging.
Slots (1-4) Page
This page provides information for each slot, such as Slot Name, Installed Unit, Power Usage, etc.
Slots (5-8) Page
This page provides information for each slot, such as Slot Name, Installed Unit, Power Usage, etc.
Slots (9-12) Page
This page provides information for each slot, such as Slot Name, Installed Unit, Power Usage, etc.
Slots (13-16) Page
This page provides information for each slot, such as Slot Name, Installed Unit, Power Usage, etc.
Control (1-8) Page
This page provides an overview of Slot settings related to Slots 1-8.
Control (9-16) Page
This page provides an overview of Slot settings related to Slots 9-16.
Gateway Page
This page allows you to configure the current session. You can either connect or disconnect the session, and also configure the packets count.
SNMP Page
This page provides an overview of SNMP-related settings. Note that configurable traps for each slot are present on this page.
Logging Page
This page displays all monitored parameters, which may be enabled or disabled.
Statistics Page
This page provides an overview of statistics such as Data Length Errors, Destination Errors, Source Errors, Dropped Packets, Processor Use, etc.
There is both a Reset Stats button and an Enable Net Stats button.
Web Interface Page
This page provides access to the original web interface of the device. However, note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.