Snell Wilcox IQMUX30 RollCall
The Snell Wilcox IQMUX30 RollCall is a multiplexer for audio streams.
About
The connector allows the management of the Snell Wilcox IQMUX30 Rollcall using a smart-serial connection.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 4674 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
Serial main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device, e.g., 192.168.14.11.
- IP port: The IP port of the device, e.g., 2050.
- Bus address: Used to fill in the unit address and the unit port, e.g., 10.04 is for unit address 0x10 and unit port 0x04.
Usage
General Page
This page contains the Display parameter and the Status Display parameter. An overview of module statuses is also displayed, such as Software version, KOS, Build, PCB, Firmware, UpTime, Licensed Options, Product and Serial Number.
Additionally, there are three buttons:
- Factory Default: Resets all module settings to factory-specified default values and clears memories
- Default Settings: Resets all module settings to factory-specified defaults but does not clear memories.
- Restar: Software restart of the module.
The parameters of the output display are also displayed.
Video Page
This page contains information about video.
Procamp Page
This page contains information about the processing amplifier, e.g., ProcAmp Enable, Black Level, Hue Adjust, Master Video Gain, Y Gain, Cb/Cr Gain, Y/C Timing, etc.
Video Delay Page
This page provides an overview of the video delay: Horizontal Delay, Vertical Delay, Frame Delay Added and Active Video Delay.
Embedder 1 Page
This page contains the audio controls for group 1.
Embedder 2 Page
This page contains the audio controls for group 2.
Embedder 3 Page
This page contains the audio controls for group 3.
Embedder 4 Page
This page contains the audio controls for group 4.
Router Overview Page
This page contains the audio controls for the groups.
Audio Page
This page contains information about the audio, e.g., Frequency, Channel ident, Internal Status, Silence Level, Overload Level, Warning Timer, etc.
Pattern & Caption Page
This page contains information about the displayed Pattern and Caption. You can also set the caption or the pattern.
Memories Page
This page provides an overview of the system memory, with a table containing 16 user memories. It also allows you to save and clear memory.
Logging Video Input Page
This page contains the input 1 log video settings and input 2 log video settings. Note that all status parameters can be enabled or disabled.
Logging Audio Input Page
This page contains the input 1 log audio settings and input 2 log audio settings. Note that all status parameters can be enabled or disabled.
Logging AES Input Page
This page contains the input AES log settings. Note that all status parameters can be enabled or disabled.
Logging Video Output Page
This page contains the output video log settings. Note that all status parameters can be enabled or disabled.
Logging Audio Output Page
This page contains the output audiolog settings. Note that all status parameters can be enabled or disabled.
Rolltrack Page
This page provides a simple command interface that can be used to send unconnected Rolltrack commands to any Rollcall-compatible unit on the network. The following parameters are displayed: Rolltrack Disable All, Rolltrack Index 1, Rolltrack Address 1, Rolltrack Sending, Rolltrack Source 1, Rolltrack Command 1 and Rolltrack Status.
Web Interface Page
This page provides access to the original web interface of the device. However, note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.