Snell Wilcox IQOTX81
The Snell Wilcox IQOTX81 is an optical transmitter.
About
This connector allows the management of the Snell Wilcox IQOTX81 using a serial connection.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 5.0.7 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
Serial main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device, e.g., 192.168.14.10.
- IP port: The IP port of the device, e.g., 2050.
- Bus address: Used to fill in the Unit Address and the Unit Port, e.g., 26.02 is for Unit Address 0x26 and Unit Port 0x02.
Usage
General Page
This page contains the Display parameter.
This page also provides an overview of miscellaneous log settings such as OS Version, Firmware version, etc.
The log settings for the parameters can be configured via the Log Config... page button.
SDI-Inputs 1-4 Page
On this page, you can configure SDI inputs 1-4.
The Output Config... page button provides an overview of the corresponding outputs.
SDI-Inputs 5-8 Page
On this page, you can configure SDI inputs 5-8.
The Output Config... page button provides an overview of the corresponding outputs.
System Memory Page
This page provides an overview of the system memory. The context menu allows you to save, recall, clear and rename a memory slot.
Logging SDI 1-4 Page
This page provides an overview of log settings related to SDI inputs 1-4.
The log settings for the parameters can be configured via the Log Config... page button.
Logging SDI 5-8 Page
This page provides an overview of log settings related to SDI inputs 5-8.
The log settings for the parameters can be configured via the Log Config... page button.
Logging Fiber Tx 1-4 Page
This page provides an overview of log settings related to Fiber Tx 1-4.
The log settings for the parameters can be configured via the Log Config... page button.
Logging Fiber Tx 5-8 Page
This page provides an overview of log settings related to Fiber Tx 5-8.
The log settings for the parameters can be configured via the Log Config... page button.
Logging Fiber Rx 1-4 Page
This page provides an overview of log settings related to Fiber Rx 1-4.
The log settings for the parameters can be configured via the Log Config... page button.
Logging Fiber Rx 5-8 Page
This page provides an overview of log settings related to Fiber Rx 5-8.
The log settings for the parameters can be configured via the Log Config... page button.
System Setup Page
This page contains information about the card, e.g., Product, Software Version, Build.
The page also contains buttons that allow you to restart the device (Restart), and set the device back to the factory settings (Factory Default) or default settings (Default Settings).
Finally, it is also possible to define a name for the different inputs here.
Rolltrack Page
This page provides an overview of RollCall-related settings.
Web Interface Page
This page allows the user to access the original web interface of the device.
Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.