Snell Wilcox IQSDA22
The Snell Wilcox IQSDA22 connector monitors and configures the IQSDA22 amplifier device.
About
The connector polls all parameters once after startup. After this, parameter updates depend on event messages generated by the device when a parameter changes. However, it is possible to manually trigger the polling of all parameters with the Force Poll button on the General page.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | V115 |
Installation and configuration
Creation
Serial Main Connection
This connector uses a single smart-serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device, by default 2050.
- Bus address: The bus of the card on the chassis. The default, UU.PP, shows the expected structure of the address, where UU is the chassis ID, and the PP is the card position, both in hex.
Usage
General
This page contains general information about the device, such as the various versions, the Serial Number, the Build Number, and more. It also contains connection info, information display and Simulated RollCall response. The latter allows you to set a custom response that will be handled by the connector as if it were received by the device. The tooltip for this functionality displays more information.
The page also includes the following buttons:
- Restart: Restarts the device.
- Force Poll: Repolls the device.
- Factory Defaults: Sets all settings back to the factory default.
Input
This page allows you to enable various settings related to each different input. You can switch the SDI input rate, mute the output, switch the input name, and specify what should happen on input loss.
Memories
On this page, you can select a memory (1-16) and edit its name, recall a previous memory (if available), and also view the Last User Memory.
The page includes the following buttons:
- Save Memory: Saves the current memory name.
- Clear Memory: Clears the current memory.
RollTrack
This page contains various RollTrack controls, such as the Address, Command, Disable all, Index, and Source. It also displays the Status and the Sending status.
Logging
This page displays Misc and Input 1 information as well as controls to enable/disable the logging of this information.
Web Interface
This page displays the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.