Snell Wilcox IQSDA32
The Snell Wilcox IQSDA32 connector monitors and controls changes on the distribution amplifier unit through a Rollcall smart-serial protocol. The card is used in the IQ Modular Chassis.
About
The connector periodically polls relevant information from the device. This happens every 15 seconds for Rollcall protocol purposes and every two hours for backchannel purposes.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 5.2 .5 |
Installation and configuration
Creation
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device, by default 2050.
- Bus address: The bus of the card on the chassis. The default, UU.PP (Hex), shows the expected structure of the address, where UU is the chassis ID, and the PP is the card position, both in Hex.
Usage
General
This page contains general information on the card hardware, including the information shown on the display of the device, and its various versions and serial numbers.
Input
This page displays the basic configuration for each of the 2 available inputs. It allows you to configure the SDI rates and On Signal Loss behavior, as well to mute the channels.
Memories
The page displays the configurable User Memory setting slots 1 to 16 of the device.
You can recall the settings from any of the previous slots with the Recall Memory option and check the last used memory setting slot in the Last User Memory.
To save a memory setting, first use the Select Memory parameter to either select one of the memory slots or select None, configure the name using the Change Memory Name parameter (which will be displayed for the corresponding Memory Name Values parameter), and select whether to Save or Clear the memory. Note that when you clear the memory, the configuration associated with it will be lost, and you will need to save it again later in order to re-create it.
Logging
On this page, you can configure the logging associated with each of the card's input systems. This includes the Inputs from the Input page and the Miscellaneous logging from the system.
RollTrack
On this page, you can check the status of and configure the RollTrack system of the card. This includes Indexes, Sources, Addresses and Commands.
Setup
On this page, you can configure the names for each input, configure data related to the board, reset settings to the defaults, and restart the device.
Connection Info
This page displays the current status of the remote connection to the card.
Web Interface
This page provides access to the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.