Snell Wilcox IQSDA35

The Snell Wilcox IQSDA35 is a dual 3G/HD/SD-SDI distribution amplifier with selectable outputs.

About

This connector uses SNMP to monitor and control a Snell Wilcox IQSDA35 device. The information and settings are displayed on different pages.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

• IP address/host: The polling IP of the device, e.g., 10.11.12.13.
• Device address: The card number, e.g., 1.

SNMP Settings:

• Port number: The port of the connected device, default 161.
• Get community string: The community string in order to read from the device. The default value is public.
• Set community string: The community string in order to set to the device. The default value is private.

Usage

General page

This page displays two groups of parameters:

• Unit Stats: An overview of the two inputs and the four outputs.
• Product: General information about the product

Input page

On this page, you can modify the settings for input 1 and input 2.

Config page

On this page, you can choose which configuration to enable. With the Mode parameter, you can choose between Config(1), Config(2) and Use Rules. If the Mode is set to Use Rules, then the configuration will be chosen by the rules that are enabled in the group box Rules.

With the Swap Config 1<>2 button, you can toggle between the two configurations.

The two page buttons underneath open a pop-up page where the settings for each configuration can be modified as needed.

Webpage

This page displays the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.