Snell Wilcox IQSDA35 RollCall
The Snell Wilcox IQSDA35 RollCall is a dual-channel 3G/HD/SD-SDI re-clocking amplifier with selectable outputs.
About
This connector allows the management of the Snell Wilcox IQSDA35 using smart-serial connection.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 5.5.8 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
Serial main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device, e.g., 192.168.56.201.
- IP port: The IP port of the device, e.g., 2050.
- Bus address: Used to fill in the unit address and the unit port, e.g., 10.0D is for unit address 0x10 and unit port 0x0D.
Usage
General Page
This page contains the Display parameter, as well as log settings parameters such as OS Version, Firmware Version, etc.
The parameters of the output display are also displayed.
Input Page
On this page, you can manage the dual-channel amplifier. The page also provides auto-changeover functionality for emergency switching, and contains the input and output GPI control.
Memory 1-16 Page
This page provides an overview of the system memory, with a table containing 16 user memories. It also allows you to save and clear memory.
Logging Page
On this page, you can select either the Logging Input 1 Config page button or the Logging Input 2 Config page button in order to enable/disable each input channel field, such as Ident, Name, Type, State and SDI Bitrate. You can also set some setting parameters such as OS Version, Firmware Version, etc.
RollTrack Page
This page provides a simple command interface that can be used to send unconnected Rolltrack commands to any Rollcall-compatible unit in the network. The following parameters are displayed: Rolltrack Disable All, Rolltrack Index, Rolltrack Address, Rolltrack Sending, Rolltrack Source, Rolltrack Command and Rolltrack Status.
Setup Page
This page contains information about the card, e.g., Input 1 Name, Input 2 Name, etc. In addition, buttons allow you to restart the device (Restart), set back the factory settings (Factory Default), or set back the default settings (Default Settings).
Web Interface Page
This page provides access to the original web interface of the device. However, note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.